Output

Provides a variety of useful inputs and outputs for various projects. Three linear slide potentiometers connected to Arduino analog pins A0, A1, and A2. Red and yellow LEDs connected to digital pins 5 and 6 (PWM pins) so you can easily vary their brightness. Three momentary push buttons connected up to the Arduino’s digital pins….

This shield allows you to use a computer power supply (or other power source) to use your Arduino to switch high current. With RFP30N06LE MOSFETS, you can easily control a lot of current directly from your Arduino. The board provides 6 PWM outputs via screw terminals. Check the datasheet for the MOSFET for full specifications….

Provides access to the VS1053 MP3/MIDI decoder hardwired in realtime MIDI mode. The VS1053 provides 31 note polyphony in 128 GM1 standard instruments along with 50 percussion instruments.

This is a motor shield for Arduino that will control two DC motors. Based on the L298 H-bridge, the Ardumoto can drive up to 2 amps per channel. The board takes its power from the same VIN line as the Arduino board, includes blue and yellow LEDs to indicate active direction, and all driver lines….

The Modkit MotoProto Shield for Arduino that makes it easy to connect up to 4 sensors and control two DC motors as well as a 16X2 character LCD. The sensor jacks accept 2.5mm cables and provide access to VCC, GND, and an analog input.

The EL Escudo is an Arduino shield that drives EL wire. Electroluminescent wire is a flexible cord that emits a florescent light. Some times referred to as ‘cool neon’ because the cord does not heat up. The problem is that EL wire runs on high voltage AC: about 125V at 425Hz. While EL wire requires….

Provides a variety of useful inputs and outputs for various projects. Three linear slide potentiometers connected to Arduino analog pins A0, A1, and A2. Red and yellow LEDs connected to digital pins 5 and 6 (PWM pins) so you can easily vary their brightness. Three momentary push buttons connected up to the Arduino’s digital pins….

The new version of this shield allows for either 3.3 or 5v logic, a separate and more robust VIN connection, and the PWM input has moved to pin 3. This is a motor shield for Arduino that will control two DC motors. Based on the L298 H-bridge, the Ardumoto can drive up to 2 amps….

Controls DC motors. Multiple outputs: The board uses a pair of L293 Dual H-Bridge driver circuits to drive up to 4 separate DC motors. High Power: The QuadMotor shield uses the L298 to allow a motor supply voltage of up to 46V and a DC current of up to 4A DC on an individual channel…..

Camera Shield is the first shield board that support photograph, it is based on the solution of VC0706 + OV7725, the former is a high performance camera processor with enhanced image processing functions and it embedded the hard-wired JPEG codec, and the latter is a high-performance 1/4 inch, single-chip VGA camera and image processor in….