Sensor

Provides 6 inputs for Hall-effect current-clamps to measure domestic and industrial power consumption. Energy usage data can be stored by the Arduino, accessed in real time, or reported to another system via wireless or wired connections. This shield also provides mounting headers for an XBee wireless module, allowing it to be part of a wireless….

Wireless sensor network node with data logging. Native RTC, On board CR2032 battery holder. GPS. XBee wireless networking. Native micro SD card socket. Stackable I2C pin header. Dual voltage (5V/3.3V) I2C hub. User defined button and LED. Unusually, this shield can be used either as a regular shield to another Arduino, or standalone using an….

Shield with BMP085 air-pressure/temperature sensor, DS1307 RTC and new in v2 additional 2*64KB EEPROM.

Shield contains the Maxim DS1307 Clock and the air pressure and temperature sensor BMP085 manufactured by Bosch Sensortec.

The Gadget Shield includes: A Freescale MMA7361L 3-axis accelerometer. A high-brightness RGB LED. 38kHz logic infrared detector. Infrared LED. Visible light sensor. Four LEDs. Two thumbwheel potentiometers. Two general-purpose momentary-contact pushbuttons.

A shield that will allow you to connect any sensor that has a BNC connector. Analog inputs are pinned out. You can select which analog pin to read from. 2 variable resistors for rough and fine tuning of the signal. MCP3202 available for 12-bit SPI hookup (not standard) Easily read any probe that produces minute….

The TCMux Shield combines a MAX6675 and Multiplexer to allow up to 8 K-Type Thermocouples to be connected to an Arduino.

The Realtime Datalog & IO shield is a platform to interface various sensor and IO modules. It provides real-time clock and SD card interface for mass storage of sensor data.

Arduino Energy Shield is a board which enables you to monitor your house, office or any other installation or equipment energy consumption. Includes headers for an Xbee module for wireless communication. Uses the ADE7753 chip which allows measurement of active power, reactive power, RMS voltage, and current.

Shield for sensor with current output 4-20 mA type 2, 3 and 4. Requires an external 9-12 VDC power supply. Includes DS1307 Real Time Clock (RTC) with coin cell holder to retain time setting.