Communication

Gives your Arduino simple wireless commumication. The embedded easy-Radio firmware handles all encode/decode functions and over air transmission of data. Features: Available in 434MHz or 868MHz Right angle SMA antenna connection User programmable frequency User programmable power output User programmable data rate Power output 868MHz Europe 5mW. USA 1mW, 434MHz 10mW Range 868MHz – excess….

The XBee shield allows an Arduino to communicate wirelessly using Zigbee. It is based on the XBee module from MaxStream. The module can communicate up to 100 feet indoors or 300 feet outdoors (with line-of-sight). It can be used as a serial/usb replacement or you can put it into a command mode and configure it….

U-Blox GSM/GPS microSD shield

The Narrowband Powerline Communication Shield can be controlled by an Arduino using SPI. You can build your own powerline communication application using this shield. The board is designed to work with 110/240V, 50/60Hz. A 1A wall adaptor is needed. Warning: High voltage present if you connect to main power.

The GPRS Dualband Shield uses the HiLo SAGEM communication module to allow GPRS communications for Arduino. You can send your data by SMS or do missed calls from your Arduino to mobile devices, or to another Arduino connected to this module.

The GPRS Dualband Shield uses the DC3500 DavisComms communication module to allow GPRS communications for Arduino. You can send your data by SMS or do missed calls from your Arduino to mobile devices, or to another Arduino connected to this module.

The Bluetooth Shield is a serial port Bluetooth module (slave) breakout board that uses the Arduino UART for Bluetooth communication.

This shield can be used to interface to existing CAN networks or used to network two or more Arduinos together using phone cable, Cat-5, or any other kind of wire.

This is an Arduino Shield for SM5100 quad-band GSM/GPRS module. The module is included.