Arduino Ro-Bot-X Designs Robot Builder's Shield
*Product is discontinued or obsolete , It is here just for your information
Arduino Ro-Bot-X Designs Robot Builder's Shield Description
The Robot Builder’s Shield makes building robots with Arduino easy. Directly plug up to 6 sensors and up to 6 servos in to dedicated connectors and drive 2 DC motors from the built in H-bridge, 1A/motor. Flip the power switch On and use the J1 jumper to transfer power from the battery to Arduino’s Vin pin.
Arduino Ro-Bot-X Designs Robot Builder's Shield Pins Note:
The diagram shows the maximum number of pins used if all connectors are populated, but in most cases only some of these pins will be used depending on what motors, servos, and sensors are connected.
Sensor pins: A0-A5
Servo pins: D8-D13
Motor pins: D4-D7
Timer1 for servos
Timer0 for motors PWM
Tags: control , motor , output , sensors , servo
Maker: Ro-Bot-X Designs
Open Source: Unknown
License: Unknown
Source: Unknown
Shield Version:
Voltage:
Current Draw:
Price:
Arduino Ro-Bot-X Designs Robot Builder's Shield Pinouts
| AREF | ||||
| GND | ||||
| D13 / SCK | ||||
| D12 / MISO | ||||
| RESET | D11/MOSI~ | |||
| 3.3V | D10 / SS ~ | |||
| 5V | D9 ~ | |||
| GND | D8 | |||
| GND | ||||
| VIN | D7 | |||
| D6 ~ | ||||
| A0 | D5 ~ | |||
| A1 | D4 | |||
| A2 | D3 ~ | |||
| A3 | D2 | |||
| A4 | D1 / TX | |||
| A5 | D0 / RX | |||
