Arduino LinkSprite CupperHead WiFi Shield
*Product is discontinued or obsolete , It is here just for your information
Arduino LinkSprite CupperHead WiFi Shield Description
This is a copy of the AsyncLabs WiShield, which is no longer made.
Arduino LinkSprite CupperHead WiFi Shield Pins Note:
D10: Slave select (SS)
D11: Master out, slave in (MOSI)
D12: Master in, slave out (MISO)
D13: Clock (SCK)
Interrupt uses only one of the following, depending on jumper setting:
D2: INT0
D8: DIG8
D9: LED (To regain use of this pin, remove the LED jumper cap)
If you setup the serial dataflash CS pin to use pin 10, then the WiFi module will not be usable. In order to use the dataflash and WiFi concurrently, the dataflash jumper CS pin must be set to pin 7.
Tags: communications , networking , wifi
Maker: LinkSprite
Open Source: no
License: Unknown
Source: Unknown
Shield Version:
Voltage:
Current Draw:
Price:
Arduino LinkSprite CupperHead WiFi Shield Pinouts
| AREF | ||||
| GND | ||||
| D13 / SCK | ||||
| D12 / MISO | ||||
| RESET | D11/MOSI~ | |||
| 3.3V | D10 / SS ~ | |||
| 5V | D9 ~ | |||
| GND | D8 | |||
| GND | ||||
| VIN | D7 | |||
| D6 ~ | ||||
| A0 | D5 ~ | |||
| A1 | D4 | |||
| A2 | D3 ~ | |||
| A3 | D2 | |||
| A4 | D1 / TX | |||
| A5 | D0 / RX | |||
