Uses three TI TLC5940 PWM LED driver ships to drive a 4×4 array of RGB LEDs. Each color is controlled by a different chip so you can adjust the reference resistors for the appropriate current. This also includes mounting positions for for three general-purpose buttons that are connected to ground, and a reset button. The TLC5940 chips are not directly connected to any Arduino pins, but a header is provided for you to make a manual connection depending on the needs of your sketch.

Pin selection is determined by the user: the buttons and FTDI chip signals are connected through jumpered headers to allow reassignment so the shield can be used on the Mega or stacked with other shields that need those pins.

         Tags: display , led , output 

Arduino Ben Combee RGB LED Shield Pinouts

				AREF
				GND
				D13 / SCK
				D12 / MISO
RESET				D11/MOSI~
3.3V				D10 / SS ~
5V				D9 ~
GND				D8
GND
VIN				D7
				D6 ~
A0				D5 ~
A1				D4
A2				D3 ~
A3				D2
A4				D1 / TX
A5				D0 / RX